how to mount a front license plate on a 2017 subaru impreza

#How to mount a front license plate on a 2017 subaru impreza how to#
#How to mount a front license plate on a 2017 subaru impreza install#
#How to mount a front license plate on a 2017 subaru impreza free#

Reinstall all parts in reverse of removal, making sure all screws are tightly secured. Align the tab on the assembly with the notch in the bulb. Insert the replacement fog light without touching the bulb directly with your hand.

#How to mount a front license plate on a 2017 subaru impreza free#

Unfasten the retainer spring by hand, which will free the bulb. Lift the rear cover off the fog light assembly. You can put this set of screws with the rest of your growing screw collection. Use the screwdriver to twist out the five screws on the rear cover of the fog light. Carefully set it on the ground, upside-down. The assembly will now be completely free. Put this pair of screws with the others in a safe place. Remove the two additional screws in the fog light assembly, again using the screwdriver, so that you can pull the light assembly out of the housing. This will reveal two more screws in the assembly. Lift the fog light cover away from the trim and set it (and the two screws) aside. Twist out the screw counterclockwise to remove it repeat this for the other screw. Insert a screwdriver into one of the two screws in the outer fog light cover.

#How to mount a front license plate on a 2017 subaru impreza how to#

How to Replace Fog Lights on a Honda Pilot Return the parts to the Santa Fe in reverse order of removal.Ĭlose the hood, and try out the Santa Fe fog lights by turning them on from inside the vehicle.

Detach the bulb from the wiring connector.Īttach the replacement fog bulb to the connector, then slide it into the assembly. Turn the assembly over, and twist the bulb half a turn counterclockwise with your hand to pull it out of the assembly. Now you have direct access to the fog light assembly. Set aside both the front bumper and the front wheel guard. Also remove the two screws on the outside edge of the front wheel guard. Remove the five screws that secure the front bumper to the vehicle, using the screwdriver. Pull the front bumper cover away from the vehicle. Use a screwdriver to twist out the six screws atop the front bumper cover. Pull out the three headlight mounting bolts, using a ratchet and socket. Locate the headlight assembly on the side of the car in need of the replace the fog light. Open and prop up the hood of the Hyundai Santa Fe. How to Replace Fog Lights in a Hyundai Santa Fe Installation of the fog light assembly is the reverse of removal. Repeat the procedure for both fog lights.

#How to mount a front license plate on a 2017 subaru impreza install#

Twist the clip on the rear of the assembly to unhook the fog light bulb, and then install the new bulb (H11). Push the rear of the fog light assembly forward to access the bulb. Unhook the wiring module from the assembly. Use the socket wrench to remove the two 10-mm bolts mounting the assembly to the car. Remove the access panel to access the rear of the fog light assembly.

Once these are removed, there will be a single clip left. Remove the screw on the outside edge of the panel, and then remove the 10-mm bolt. The panel must be removed to replace the fog lights. Look underneath the fog light assembly to find the access panel. Turn the fog lights and the engine off before beginning. How to Replace the Fog Lights on a Nissan Maxima 2-ton or greater capacity, low-profile jack